Can a guy take a 64mm 4 weight crank and have 10mm shaved off the front so I don't have to buy a spacer?
Thanks
dean
Crankshaft Machining
-
dingo151
- Making Progress
- Posts: 57
- Joined: December 11th, 2008, 11:07 am
Crankshaft Machining
"You'll bunk with private Joker. He's silly and he's ignorant but he's got GUTS and guts are enough!"
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Crankshaft Machining
Yes
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
dingo151
- Making Progress
- Posts: 57
- Joined: December 11th, 2008, 11:07 am
Re: Crankshaft Machining
Thanks Man!
"You'll bunk with private Joker. He's silly and he's ignorant but he's got GUTS and guts are enough!"
-
Muad'Dib
- Site Admin / Owner
- Posts: 1505
- Joined: January 8th, 2008, 10:55 am
- Stroker Displacement: 4.7L
- Vehicle Year: 1990
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Oregon
- Contact:
Re: Crankshaft Machining
When this is done, does the bolt hole need to be re-tapped? Or is it still deep enough for the HB bolt after being shaved?
If it feels right, then STROKE it!
Who is online
Users browsing this forum: Amazon [Bot], Bing [Bot], Semrush [Bot] and 6 guests