Dowels missing after machine work

Post by **akadeutsch** » September 5th, 2014, 4:08 pm

I am sure this is a dumb question but I am lost. I just had my block decked and when I got it back the locating dowels for the head were gone.

I am sure that they had to remove them to do the work but where do I get new ones and how do I put them in?

Post by **the grey ghost** » September 5th, 2014, 7:20 pm

Tell the shop that its their fault and you want them back

Post by **akadeutsch** » September 6th, 2014, 9:35 am

Yeah, they had them. and they apologized for not putting them back in.

Post by **woodjeep** » September 19th, 2014, 7:43 am

just a side note...the dealer sells replacement dowell pins for a couple of bucks each