Page 1 of 1
AEM F/IC Oxygen Sensor Hook Up...
Posted: January 26th, 2014, 6:03 pm
by Alexia
If I will be tuning via AEM's UEGO wideband sensor does the AEM F/IC really need to tap into the stock narrowband oxygen sensor? The only reason I can see it needing to do this is for changing the signal in case the PCM freaks out over the AFR changing against what it thought should happen after the F/IC adjusts other parameters. The other, why does it tap with 1k OHM resistor instead of intercepting?
Re: AEM F/IC Oxygen Sensor Hook Up...
Posted: January 27th, 2014, 4:35 am
by SilverXJ
You don't have to tie into the factory narrow band. As for adjusting it really doesn't work. I tried it every which way on mine and it either doesn't do anything or makes it go very lean or very rich.
Re: AEM F/IC Oxygen Sensor Hook Up...
Posted: January 27th, 2014, 7:41 am
by Alexia
SilverXJ wrote:You don't have to tie into the factory narrow band. As for adjusting it really doesn't work. I tried it every which way on mine and it either doesn't do anything or makes it go very lean or very rich.
I have seen a few others around the internet that indicated the only way they got it to work was using a much higher value of resistor. I will just leave the wire capped off in the harness for now.