Page 1 of 1
Valve cover?
Posted: July 24th, 2012, 12:14 pm
by haroldpo6
Will a 1996 4.0 valve cover fit on a 1995 4.0?
Re: Valve cover?
Posted: July 24th, 2012, 7:18 pm
by cruiser54
Yes, it will.
Re: Valve cover?
Posted: July 25th, 2012, 4:19 am
by haroldpo6
I noticed when looking at valve cover gaskets they list 96 and up, not for a 95?
Re: Valve cover?
Posted: July 25th, 2012, 7:24 am
by haroldpo6
Also the head for the 95 is 7120
The head for the 96 is 0630
but will the cover interchange?
anybody
Re: Valve cover?
Posted: July 25th, 2012, 5:39 pm
by SilverXJ
Head doesn't matter as far as valve cover fit is concerned. The later steel valve cover will fit on earlier heads. The only thing that changes are the PCV elbows and grommets.
Re: Valve cover?
Posted: July 25th, 2012, 6:27 pm
by haroldpo6
SilverXJ wrote:Head doesn't matter as far as valve cover fit is concerned. The later steel valve cover will fit on earlier heads. The only thing that changes are the PCV elbows and grommets.
Thanks
Re: Valve cover?
Posted: July 27th, 2012, 5:53 pm
by haroldpo6
SilverXJ wrote:Head doesn't matter as far as valve cover fit is concerned. The later steel valve cover will fit on earlier heads. The only thing that changes are the PCV elbows and grommets.
Just finished installing, fits like a glove.
Re: Valve cover?
Posted: July 28th, 2012, 6:34 pm
by woodjeep
The stamped steel 96 and up will fit all years because the bottom is flat...the 95 and down cast alluminum will not due to the ridge on the bottom. I ground down my ridge so the bottom was flat so my 92 cover fit my 96 head.
Re: Valve cover?
Posted: July 29th, 2012, 9:02 pm
by Muad'Dib
Yeah... i used a VC from a 2000 on my 90 RENIX. Just had to change out my CCV stuff (which is a good idea anyway).