Jeep Strokers

With .040" shaved off the deck to get ground zero with the piston
.004-.005 off of the head to clean it up.
Stock springs
Very mild rv cam, lobe lift .258" stock- .253"
Printoseal 9076pt1 head gasket, I believe .051
Does it appear that I am still in the safety zone from making contact with valve and piston or
Just getting ready to bolt down the head.
Thanks for your opinions in advance!
Greg.

You will be fine. Last time I checked mine was with the Comp Cam 68-231-4 and I had a lot. I can't recall a number, but it was a lot. I have it detailed in my thread, but I say 1/6" w/o head gasket and a shim under the rocker, but I don't know if I meant 1/16"

Thank you Silverxj, very much appreciated!
Greg.