Page 1 of 1

Where does this go pt. 1

Posted: September 5th, 2011, 11:03 am
by jbxx
OK I'm at the point of having the handfull of parts at the end ( or close to it )
I would like to pick your collective brains here!
Most of the unknown parts are gaskets, or in this case an "O" ring.
Three O rings in the gasket kit; lg., med., and small. Where does the small one go?
Large
Image
Med.
Image
and small.
Image
Part that bolts into block that holds oil filter (dim)
Image

More to come! There are about 6 gaskets that I can't identify.
Thanks!
J.B.

Re: Where does this go pt. 1

Posted: September 5th, 2011, 11:02 pm
by Muad'Dib
Look at the second picture... Next to the finger nail that is pointing to the outer medium size o-ring that has the smaller one on it. See where the bolt is there?? Look at the pic again closer and you can see the o-ring on the bolt right next to your nail.

Hope that helps.

Re: Where does this go pt. 1

Posted: September 6th, 2011, 4:48 pm
by jbxx
Here?
Image

Re: Where does this go pt. 1

Posted: September 6th, 2011, 4:55 pm
by jbxx
Yep, that was it. It was flattened and hard as my grannies tonails.
Tnx.
More to come! I think I will open them all under the same thread, just one at a time. Thanks again!
J.B.