Mains studs
Posted: February 24th, 2011, 5:27 pm
Got a HESMS6 mains stud kit from Hesco.
Machinist says they won't work.
I go to the shop, sure enough they are way too long, wont even snug down on the mains.
Tap the hole out deeper, still wont even snug down.
I think these are made for a setup with a girdle.
Bought 2nd set ARP 4.060 - 1lb.
Fits good. Maybe just a fluke block?
J.B.
Machinist says they won't work.
I go to the shop, sure enough they are way too long, wont even snug down on the mains.
Tap the hole out deeper, still wont even snug down.
I think these are made for a setup with a girdle.
Bought 2nd set ARP 4.060 - 1lb.
Fits good. Maybe just a fluke block?
J.B.