Page 6 of 6
Re: FNG 4.6 Long Rod
Posted: June 8th, 2012, 9:06 am
by dwg86
Good to hear the stroker is running good. Yoy might want to check your valve adjustment. My RR's made no noise with a fairly agressive (fast) ramp on the cam (214 dur @ .050 / .501 lift).
Re: FNG 4.6 Long Rod
Posted: June 8th, 2012, 9:40 pm
by Muad'Dib
Which Magnecor's were you running? Mine have been great... i run the KV85's.. although i did break a couple because of my own stupidity. Dont try to pull them off when the engine / wires are hot
.
Re: FNG 4.6 Long Rod
Posted: June 11th, 2012, 3:28 pm
by Antifreeze2
I had the KV85's. It was possible that they wore out from being pulled too often, but I still find that hard to excuse.
When adjusting RR's, what is the correct preload? With empty lifters, it's 1/2 turn. What about full?