Bearings
-
Mgardiner1
- Donator
- Posts: 574
- Joined: August 2nd, 2008, 6:19 pm
- Stroker Displacement: 284 CI
- Location: Wading River, NY
Re: Bearings
Should have let me know, i would have pressed them off for you
oletshot wrote:....and silvolites are only cast not hypericantspellits.
-
Cheromaniac
- I live here
- Posts: 3252
- Joined: March 8th, 2008, 12:58 pm
- Stroker Displacement: 4563cc
- Vehicle Year: 1992
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Cyprus
- Contact:
Re: Bearings
Sounds like the Brazilian bearings are the better option 'cause that hole in the rod bearings is for the oil to sling out of the rod cap and lubricate the cam lobes.Mgardiner1 wrote:Definitly not happy, just noticed the Brazil bearings have the oil notch that lines up with the notch on the rod cap for oil slinging, and the USA ones do not.
1992 XJ 4.6 I6 - 5MT - Stroker build-up, Stroker "recipes" Sold
1995 Mustang GT - 4AT - Modded Sold
2006 Mustang GT - 5MT - Modded Midlife Crisis Car
1995 Mustang GT - 4AT - Modded Sold
2006 Mustang GT - 5MT - Modded Midlife Crisis Car
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Bearings
If I knew you had the press to do it I would have.Mgardiner1 wrote:Should have let me know, i would have pressed them off for you
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Bearings
Yes, but try asking for the Brazilian made bearings when placing an order with most part houses.Cheromaniac wrote:
Sounds like the Brazilian bearings are the better option 'cause that hole in the rod bearings is for the oil to sling out of the rod cap and lubricate the cam lobes.
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
Who is online
Users browsing this forum: No registered users and 8 guests