Introduction and need stroker advice.
-
CrankyD
- Noob
- Posts: 17
- Joined: November 19th, 2014, 4:56 pm
- Vehicle Year: 1983
- Vehicle Make: AMC jeep
- Vehicle Model: cj7
Re: Introduction and need stroker advice.
Thanks again!
-
CrankyD
- Noob
- Posts: 17
- Joined: November 19th, 2014, 4:56 pm
- Vehicle Year: 1983
- Vehicle Make: AMC jeep
- Vehicle Model: cj7
Re: Introduction and need stroker advice.
Well the choices have been finalized and this is what I ended up going with;
4.0 NVH block
ic944-030 pistons
Mopar P4529229ac cam and lifters
Edelbrock 50169 head
Deck block .020, pistons .009 in the hole.
~9.8:1 compresion
looking forward to finishing her off!
4.0 NVH block
ic944-030 pistons
Mopar P4529229ac cam and lifters
Edelbrock 50169 head
Deck block .020, pistons .009 in the hole.
~9.8:1 compresion
looking forward to finishing her off!
You do not have the required permissions to view the files attached to this post.
-
bgmiller
- Posts: 8
- Joined: May 25th, 2015, 12:39 am
- Vehicle Year: 1997
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
- Location: El Paso, TX 79938
Re: Introduction and need stroker advice.
Do you have the engine in and running? I am following your build because I like many others are in the planning stages for a stroker build.
Who is online
Users browsing this forum: Bing [Bot], Google [Bot] and 4 guests