Carbide burrs for poorting...

[Dezertxj88]

Hey guys so far I've had my Renix head checked out...yup a Renix, all was good. Gonna be cool to pop the hood and have all the old Renix stuff...and a turbo
Hot tank/magnaflux-$20

Anyway before I started porting it I thought I should post up what I've got, and see if I should add to it, and what exactly should I add! I'm confident in doing this job myself, ported a few honda heads for some guys & myself a few years back..not to hard, just go slow and don't take too much away, mainly cleaning up, gasket matching ect.
I already have a 90 piece "Jegs porting kit"..its got 90 pieces, large-small but only 80 & 120 grit. I have a few die grinders, both air and electric. I have a great lighting source..I have an old dentist like light that bends into any position which will be nice.

Anyway, should I grab some stones? Rougher or smoother rolls? And I want to grab a few carbide burs..I know I need to be careful with these lol!

Would these carbide burs be ok to port an iron head?
http://www.ebay.com/itm/10-Pcs-Solid-Ca ... 19cb12e4c6

[SilverXJ]

Those burrs should work fine. They are definitely from china so they might not hold up too long, but you also might not use them a lot.

[Retlaw01XJ]

They're even shipping from China! Hope you're not in a hurry to get them.
I would get some larger diameter ones too. I usually buy them at swap meets.