tranny mount

Post by **shawnxj** » July 4th, 2011, 4:08 pm

so i picked up a engine stand today and went to mount the block on the stand and noticed i'm missing the passenger side insert that holds the tranny up and has the threads for the bolt. anybody know what it's called and where i can get 1? i need to assemble the block so i can measure the deck height

Post by **SilverXJ** » July 4th, 2011, 5:15 pm

Are you talking about the... ummm.. the technical word escapes me now for some reason... but its the cylindrical thing that is on the block 'wing' that aligns the transmission and engine? It might be a dealer only item. But if you just need to put it on the engine stand for now you don't need that.

Post by **shawnxj** » July 4th, 2011, 5:45 pm

ya that thingy

Post by **IH 392** » July 4th, 2011, 11:05 pm

The "hollow alignment dowel" that aligns the bell housing to the block?, it has no threads in it, the threads are in the block, is it stuck in the bellhousing?

Post by **shawnxj** » July 5th, 2011, 4:48 pm

it might be but i don't have that transmission. i bought this block off a guy in dallas and he has a new motor in his jeep already

Post by **BADASYJ** » July 7th, 2011, 3:54 am

Maybe try a tranny shop. I would think they should have some laying around that might fit. Or at least they could steer you in the right direction to find some.

tranny mount

tranny mount

Re: tranny mount

Re: tranny mount

Re: tranny mount

Re: tranny mount

Re: tranny mount

Who is online