I am building my first jeep engine and need some help. i would like to know if the parts will work
crank is a 4.2 crank from SCAT
i want to use 4.2l rods from 505performance and IC 944-020 pistons.
i don't plan on zero decking the block i know that will increase the quench.
need help
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: need help
With the IC 944s you need the 4.0L rods, not the 4.2L rods.
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
apsracing
- Posts: 3
- Joined: December 23rd, 2010, 6:41 pm
- Vehicle Year: 1995
- Vehicle Make: jeep
- Vehicle Model: yj
Re: need help
yes thats what i meant to type
http://www.shop.505performance.com/prod ... egoryId=29
and with them i shouldn't have an interference issue
http://www.shop.505performance.com/prod ... egoryId=29
and with them i shouldn't have an interference issue
-
dragginwagon406
- Making Progress
- Posts: 51
- Joined: May 21st, 2008, 8:25 pm
- Stroker Displacement: 4.6L
- Vehicle Year: 1998
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
Re: need help
Just be careful with the corners of the small end balance pad to the inside of the piston.
Who is online
Users browsing this forum: Google [Bot] and 1 guest