Turns out my indexing of the dizzy housing was fine, but I had the gear a tooth off. Runs like a top now. Thanks for the suggestions everybody and for the write ups (Dino/dwg86). Now to prevent it from chewing up more dizzy gears..................
Code P0340 and my TJ won't start
-
SkylinesSuck
- Donator
- Posts: 545
- Joined: February 14th, 2009, 11:11 pm
- Stroker Displacement: 4.6L
- Vehicle Year: 1998
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
- Location: Northern VA
Re: Code P0340 and my TJ won't start
Well, I've got them to do it for free 2 times in the past at two different dealerships when I was stationed in Texas, but I just showed up and walked into the shop. This time I called and that may have made the difference. Didn't need it this time anyways.
Turns out my indexing of the dizzy housing was fine, but I had the gear a tooth off. Runs like a top now. Thanks for the suggestions everybody and for the write ups (Dino/dwg86). Now to prevent it from chewing up more dizzy gears..................
Turns out my indexing of the dizzy housing was fine, but I had the gear a tooth off. Runs like a top now. Thanks for the suggestions everybody and for the write ups (Dino/dwg86). Now to prevent it from chewing up more dizzy gears..................
-
dwg86
- Donator
- Posts: 1245
- Joined: February 13th, 2008, 6:20 pm
- Stroker Displacement: 4.6
- Vehicle Year: 2003
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
Who is online
Users browsing this forum: No registered users and 2 guests