I need a little help here. I'm nearly done getting the stroker installed and have run across a small problem. The power steering braket doesn't fit anymore. Their is one bolt in the block, one that attaches to the steering, and 2 that attach to the intake manifold. The 2 holes in the braket that attache to the manifold are short (below) by about 1/8". Do I need a braket from a 4.0 engine? The braket I am trying to use is stock and from my 85 CJ7. Clifford Intake BTW (might be the problem?) I'm going to try and post some pictures later.
Suggestions??
Power Steering Bracket
-
blk85cj7
- Where's the "any" key?
- Posts: 29
- Joined: September 19th, 2009, 3:10 am
- Stroker Displacement: 4.6
- Vehicle Year: 1985
- Vehicle Make: Jeep
- Vehicle Model: CJ7
- Location: Marietta, GA
-
blk85cj7
- Where's the "any" key?
- Posts: 29
- Joined: September 19th, 2009, 3:10 am
- Stroker Displacement: 4.6
- Vehicle Year: 1985
- Vehicle Make: Jeep
- Vehicle Model: CJ7
- Location: Marietta, GA
Re: Power Steering Bracket
Anyone? I'll hopefully post some pictures tomorrow night.
-
gradon
- Donator
- Posts: 1353
- Joined: February 13th, 2008, 5:33 pm
- Stroker Displacement: 4.6/280ci
- Vehicle Year: 1996
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: DC
Re: Power Steering Bracket
I wonder what year the clifford manifold ps setup would be similar to?(87-90, 91-95, 96+)? I'm pretty sure I have a bracket for a 91-95 setup in the shed. I also have a spare ps setup from the 90 comanche that we're working on(bro wants the hydroboost). You should post some pics.
Who is online
Users browsing this forum: No registered users and 1 guest