intake question for the stroker noob!!

[dannyroark89]

hey guys sorry if this is a newbie question, getting ready for my first stroker build and couldn't be more excited... i have 2 questions... one the intake, if i were to run a cowl induction type intake would it limit the amount of air to much thats getting to the motor i know with a stock 4.0 its fine but not sure with it being stroked... also as far as the exhaust manifold i would imagine the stock one is a little to small eh? what would be a good one to look into? and if the cowl induction is a bad idea whats another alternative to the stock air box?

thanks guys

[omegatron]

As far as the exhaust...I bought mine off of ebay....it is the t409 stainless steel banks look-a-like...for $165 w/ free shipping! Just got it last week and it looks pretty sweet...tubes are bigger 1 5/8'' and it comes with all the gaskets....i will try to post a link here


http://cgi.ebay.com/ebaymotors/91-99-JE ... ccessories

and for the intake...i would just peruse craigslist...some great deals to be found ( i bet you could find a cold air intake for under $100). hope that helps.

[Muad'Dib]

That looks like (and probably is) the apn header that alot of people have been using on NAXJA:

http://www.ineedparts.com/index.php?tar ... t_id=15343

[dannyroark89]

cool thanks guys that answers the header question!! buying it in a few minutes haha but ya cold air is what im looking for but will having it in my cowl mess up the amount of air needed for the larger motor? i can build it for about 60$ with the cone filter from summit.