Machining Piston Dish

[brccurry]

Hi Everyone,
I am new here and have been doing a lot of research on strokers. I am collecting parts to build a 4.6 stroker using the
information I have picked up from this forum.
I have seen pictures of pistons that were machined be Oleshot and am very interested in getting a set of Silvolite 2229 pistons machined by him.
Anybody know how to get ahold of him? I have tried email and pm and haven't got any replies.
Maybe I am not doing it right.
Thanks for all your help!

[Muad'Dib]

Hi Everyone,
I am new here and have been doing a lot of research on strokers. I am collecting parts to build a 4.6 stroker using the
information I have picked up from this forum.
I have seen pictures of pistons that were machined be Oleshot and am very interested in getting a set of Silvolite 2229 pistons machined by him.
Anybody know how to get ahold of him? I have tried email and pm and haven't got any replies.
Maybe I am not doing it right.
Thanks for all your help!

It shows him last active today on the forums .. so either you have done it wrong or he has yet to get back to you.

Once way to know if he has received your private message is to check to see if the message you sent him is in the "Outbox" or "Sent Messages" folder. If its in the outbox, then it has yet to be opened by him. If its in the "Sent Messages" folder he has gotten the PM, now you just wait for a response

Good Luck

[brccurry]

Problem solved!
Talked to him today, he is on vacation.
Thanks for everyones help.
I hope to get started on the stroker build very soon!!!