Ok, never done this before. There is a hole where the cam goes on the back (bell housing area). Is this where the 2 3/64 freeze plug goes? Any other thing about cam installation worth mentioning?
Thanks so much, I'm so glad to have this forum to help me out! You guys are great!
Cam installation question
-
jn2630
- Learning to use the board
- Posts: 39
- Joined: April 12th, 2009, 3:07 pm
- Stroker Displacement: 4.6
- Vehicle Year: 1993
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
-
SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Cam installation question
There is a freeze plug that goes in the back of the block. IIRC its a rather thin plug.
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
John
- I love JeepStrokers.com!!
- Posts: 709
- Joined: February 13th, 2008, 8:35 pm
- Stroker Displacement: 4.6
- Location: West Virginia
Re: Cam installation question
And you want to make sure the camshaft does not rub this plug when assembled. A bad way to control camshaft thrust. Creates problems if the cam wears a hole in the plug as well.
John
John
Who is online
Users browsing this forum: Ahrefs [Bot], Amazon [Bot] and 6 guests