Jeep Strokers • Crankshaft Machining

Page 1 of 1

Crankshaft Machining

Posted: March 16th, 2009, 6:57 pm

by dingo151

Can a guy take a 64mm 4 weight crank and have 10mm shaved off the front so I don't have to buy a spacer?

Thanks
dean

Re: Crankshaft Machining

Posted: March 16th, 2009, 7:31 pm

by SilverXJ

Yes

Re: Crankshaft Machining

Posted: March 16th, 2009, 7:41 pm

by dingo151

Thanks Man!

Re: Crankshaft Machining

Posted: March 25th, 2009, 1:23 pm

by Muad'Dib

When this is done, does the bolt hole need to be re-tapped? Or is it still deep enough for the HB bolt after being shaved?