DCR calculators
-
Exos
- Consistent
- Posts: 280
- Joined: December 2nd, 2008, 1:35 pm
- Stroker Displacement: 4.7L
- Vehicle Year: 1998
- Vehicle Make: Jeep
- Vehicle Model: XJ
- Location: Quebec, Canada
DCR calculators
Why don't I ever get the same results with our own CR calculator, and the one made by Pat Kelly? Imputs are the same, but some fields are different, mainly in cam specs. But I always get about 1 point difference in compression ratio.
-
Muad'Dib
- Site Admin / Owner
- Posts: 1497
- Joined: January 8th, 2008, 10:55 am
- Stroker Displacement: 4.7L
- Vehicle Year: 1990
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Bend, Oregon
- Contact:
Re: DCR calculators
Its hard to say really... calculations could be incorrect .. information could be incorrect. Heck, instructions could be read wrong, or even not worded correctly!
If it feels right, then STROKE it!
You're lucky that hundred shot of CAPS LOCK didn't blow the welds on the forum!!
-
Flash
- I love JeepStrokers.com!!
- Posts: 693
- Joined: February 17th, 2008, 10:45 pm
Re: DCR calculators
Last time i check ours agence Pat's it was petty darn close.............But it has been a while since i played with either of them.....................................
Flash
Flash
89 XJ with 300,000 on the original eng
"I've also never completed a motor, yet. My mouth (fingers) is also writing checks my ass can't cash."
"I've also never completed a motor, yet. My mouth (fingers) is also writing checks my ass can't cash."
Who is online
Users browsing this forum: Bing [Bot] and 25 guests