Page 1 of 1
Crank position sensor location
Posted: May 17th, 2024, 1:39 pm
by AMCRAISED
I'm switching from a Peugeot 5 speed to an AX15. The AX15 came from a boneyard and was completely rebuilt. I believe it is a 1992 transmission. It moves the CPS from 12:00 to approximately 10:00. The question is about timing. will this conflict with my 1989 Renix computer and timing? If so, what is a recommended fix?
Re: Crank position sensor location
Posted: May 17th, 2024, 2:58 pm
by AMCRAISED
Just realized the answer is yes as the cps reads the flywheel so I need to replace the flywheel.
Re: Crank position sensor location
Posted: May 19th, 2024, 6:43 am
by amcinstaller
It's been a minute since I looked at the trigger wheel spacing. I know some are sets of 3 or 4 and some are just even spaced the whole way around. Is it possible to add/fab something to put the cps where you need it? What car is this in?