Page 1 of 1
258 crank spacer for serpentine belts
Posted: February 19th, 2022, 9:07 am
by Crockodotsky
Anyone know where I can get a spacer for my 258 crank? I'm having trouble bringing myself to buy a $42 spacer and then pay $20 to have it shipped from Newcomer. $62 for a big washer???
Re: 258 crank spacer for serpentine belts
Posted: February 19th, 2022, 11:34 pm
by Russ Pottenger
$40.00 shipped if that helps.
Russ Pottenger
Bishop-Buehl Racing Engines
531 N. Lyall Avenue
West Covina, California 91790
Work (626) 967-1000
Cell (626) 673-2203
Email:
[email protected]
Re: 258 crank spacer for serpentine belts
Posted: February 19th, 2022, 11:44 pm
by Cheromaniac
You can make your own spacer by slicing the rearmost 10mm off an old harmonic balancer on a lathe.
Re: 258 crank spacer for serpentine belts
Posted: February 22nd, 2022, 4:32 pm
by Crockodotsky
thanks for the advise. So I can assume that the spacer is 10mm in depth?
Re: 258 crank spacer for serpentine belts
Posted: February 22nd, 2022, 5:59 pm
by IH 392
I just cut the end of the crank off.
Re: 258 crank spacer for serpentine belts
Posted: February 22nd, 2022, 11:06 pm
by Cheromaniac
Crockodotsky wrote: ↑February 22nd, 2022, 4:32 pm
thanks for the advise. So I can assume that the spacer is 10mm in depth?
Yes.