Page 1 of 1
Valve cover (edelbrock head, roller rocker arms)
Posted: January 2nd, 2018, 8:12 pm
by BcurpKodiak
I am trying to figure out exactly what valve cover will work for my application, maybe without mods if that's possible.
I have the edelbrock aluminum head and am using 1.65 Harland sharp roller rockers.
Is there a valve cover that will drop right onto that setup?
Re: Valve cover (edelbrock head, roller rocker arms)
Posted: January 3rd, 2018, 2:53 am
by SkylinesSuck
I think must people run a spacer or just double gasket.
Re: Valve cover (edelbrock head, roller rocker arms)
Posted: January 3rd, 2018, 7:35 am
by Russ Pottenger
The cast finned Crown cover will work.
All other covers require some level of clearancing
Re: Valve cover (edelbrock head, roller rocker arms)
Posted: January 3rd, 2018, 3:41 pm
by BcurpKodiak
https://www.quadratec.com/products/51104_08_07.htm
Like that one? I don't know exactly which one or years is finned and cast
Actually that seems like it must be stamped.
Do 4.2L valve covers work?
Re: Valve cover (edelbrock head, roller rocker arms)
Posted: January 3rd, 2018, 3:59 pm
by SkylinesSuck
I have read 4.2L valve covers are not compatible. No first hand experience though.
Re: Valve cover (edelbrock head, roller rocker arms)
Posted: January 3rd, 2018, 6:33 pm
by Russ Pottenger
That's the cover Brandon.