Page 1 of 1
Clifford intake manifold?
Posted: July 3rd, 2017, 8:47 pm
by MunkMaster
Just curious but would the Clifford intake that is meant for the carbed 4.0s work with efi with some figuring out. and if so would it really do anything different and or better than the newer model intake manifold?
http://www.shop.cliffordperformance.net ... 4520WH.htm
Re: Clifford intake manifold?
Posted: July 4th, 2017, 11:03 pm
by Cheromaniac
You could potentially adapt that manifold for EFI, but why bother when you can get an '00+ intake for a fraction of the cost? You could do the reverse and adapt the late model intake for a carb set-up.
Re: Clifford intake manifold?
Posted: July 4th, 2017, 11:10 pm
by MunkMaster
That's the route I am going I was just a little curious. I always liked the settup that we're just a little different than the rest.
Re: Clifford intake manifold?
Posted: July 10th, 2017, 9:27 am
by jeepman
Yes easy enough if you want to go Fuel injected but not do a complete conversion...
If I were to build a CJ again with a 4.0L stroker conversion I would go with this FAST EFI kit...
FAST EFI page
http://www.fuelairspark.com/fas/ez-efir ... ystemhtml/