Engine light went on and i got these codes in the pic
O2 sensors malfunctioned because the pervious owner installed loacl headers and complete exhust system without catalytic converter , i am plaining to install magna flow spunk catalytic and i hope i will be able to solve o2 sensors problems
P1491 -- because pervious owner cancelled mechanic fan and installed electrical volvo fan instead , fan working fine but i do not know how to solve this
P0118 -- i think thermostat malfunctioned
P0500 -- harness issue
MY CONCERN IS ABOUT p0443 and p1689 , i am not yelling here but trying to highlight the main issue
P1689 -- i searched for TCM in my car but couldont find it , i do nit know if my car is equipped with ine from factory or not
P0443 -- i think this because a circle box on driver side near to headlight , i do not know it's name, went broken and could not find a new one
Any help would be apperciated
My jeep is a tj 2000 model shara 6 clyinder with manual transmission Ax15
Does manual tj has TCM ?
-
- Posts: 7
- Joined: August 20th, 2015, 5:20 am
- Vehicle Year: 2000
- Vehicle Make: jeep
- Vehicle Model: tj
Does manual tj has TCM ?
You do not have the required permissions to view the files attached to this post.
- SilverXJ
- Global Moderator
- Posts: 5790
- Joined: February 14th, 2008, 7:14 am
- Stroker Displacement: 4.6L
- Vehicle Year: 2000
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Radford, Va
Re: Does manual tj has TCM ?
There are two descriptions for P1698. The one is the transmission, the other is
P0118: No, if the engine temp went so high as to send the sensor out of range the engine would be damaged. Check the sensor and wiring.
That is a lot of codes for just one time that the engine light went on.
P1491: The does the Volvo fan run all the time, like the PO bypassed the stock wiring, or does it come on at a certain temp? How is it wired in?
I would check the wiring harness since you seemed to indicate a problem with it.P1698 No CCD Messages Received From PCM Bus communication failure to PCM. A "Companion DTC" was set in both the ECM and PCM.
It is called an EVAP purge solenoid. A mechanic/ good part store monkey could have told you what the broken one was.P0443 (M) Evap Purge Solenoid Circuit An open or shorted condition detected in the EVAP purge solenoid control circuit
P0118: No, if the engine temp went so high as to send the sensor out of range the engine would be damaged. Check the sensor and wiring.
That is a lot of codes for just one time that the engine light went on.
P1491: The does the Volvo fan run all the time, like the PO bypassed the stock wiring, or does it come on at a certain temp? How is it wired in?
2000 XJ. 4.6L stroker
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
00+ Viper Coil Swap | CPS Timing Increase Mod | Fabricated Airbox | Dash bezel, Arduino Multigauge & RD Conceal
Eat, breath, drink, sleep, Jeep, drink
-
- Posts: 7
- Joined: August 20th, 2015, 5:20 am
- Vehicle Year: 2000
- Vehicle Make: jeep
- Vehicle Model: tj
Re: Does manual tj has TCM ?
SilverXJ wrote:There are two descriptions for P1698. The one is the transmission, the other isI would check the wiring harness since you seemed to indicate a problem with it.P1698 No CCD Messages Received From PCM Bus communication failure to PCM. A "Companion DTC" was set in both the ECM and PCM.
It is called an EVAP purge solenoid. A mechanic/ good part store monkey could have told you what the broken one was.P0443 (M) Evap Purge Solenoid Circuit An open or shorted condition detected in the EVAP purge solenoid control circuit
P0118: No, if the engine temp went so high as to send the sensor out of range the engine would be damaged. Check the sensor and wiring.
That is a lot of codes for just one time that the engine light went on.
P1491: The does the Volvo fan run all the time, like the PO bypassed the stock wiring, or does it come on at a certain temp? How is it wired in?
Yes it is evap purge solenoid , i could not find a new one.
Temp went so high and coolant water was boiling in the reservoir , so i took themostar out and the temp went down . I will change thermostate First and cheak again .
And the fan The PO bypassed the factory wiring and made it run all the time . Wiring in is a little bit complicated , he used a seperate relay and connected positive and negative wires between the relay and battery and also starter relay
If you intersted , i will explain it further
Who is online
Users browsing this forum: No registered users and 27 guests