Jeep Strokers

I have been working on tuning and have built a stock jeep timing table based on "Base + Mech + Vacuum" and thought I would share the information. The table is base on max advance.

Ive been running the AEM F/IC 6 piggyback for a few weeks now . its not too bad . im surprised no body is interested in fuel maps and ignition timing.

Thanks!

I 've been using your table to get a kindof baseline for my carbureted / vacuum distributor setup. I know there's so many variables like CR's and such, but do you think the info in your table is transferable to a non-efi/computer controlled setup?

I too have looked pretty hard for timing info for these strokers and have come up empty. Maybe cause the ECM's do all the thinking and adjusting?
Anyway, I was stoked to find your table last year and appreciate you sharing it. Saw that it was ressurected so I thought I'd ask!

1scram wrote: ↑August 11th, 2015, 1:59 pm I have been working on tuning and have built a stock jeep timing table based on "Base + Mech + Vacuum" and thought I would share the information. The table is base on max advance.

Where can I see the table.

Load is in torr. You will have to convert to kPa, Psi, etc.

Stock timing in my 2004 TJ.
What I run with my 2004 TJ.

Brianj5600, thanks a lot!
What is torr?

darkcorp wrote: ↑September 7th, 2022, 7:35 amWhat is torr?

Wikipedia is your friend:

https://en.m.wikipedia.org/wiki/Torr#:~ ... 3.32%20Pa).