Sure has been quite here lately. Anybody up to anything good ?
After a number of upgrades and improvements to my YJ as a whole I have come to the conclusion that changing to JTEC and using a programmed ECM that matches my setup is the next step. The tweaked SBEC makes it run decent but I know not optimum. Plenty of room for improvement in a number of different areas.
FWIW, for those running SBEC the 96 JTEC XJ harness keeps all the same sensor connectors as the SBEC.
In fact, the architecture of the SBEC to JTEC engine control is so close you could actually add the JTEC protocol using the SBEC harness by repining the SBEC or for the lazy cut and splice the wires..
Looking for Input
-
- My keyboard is getting warn out
- Posts: 1032
- Joined: February 28th, 2008, 3:13 am
- Stroker Displacement: 4.9
- Location: Michigan
-
- Consistent
- Posts: 218
- Joined: October 16th, 2014, 3:35 pm
- Stroker Displacement: 4.6
- Vehicle Year: 2000
- Vehicle Make: XJ
- Vehicle Model: Sport
Re: Looking for Input
It has been awfully quiet around here. I was offline for about a week and came back hoping to find a couple pages of new posts...bummer. I'm still waiting on some slugs for my heap.
Who is online
Users browsing this forum: No registered users and 1 guest