Looking for Input

Off topic, play nice. No Nudity, Pornographic material etc..
Post Reply
jsawduste
My keyboard is getting warn out
My keyboard is getting warn out
Posts: 1032
Joined: February 28th, 2008, 3:13 am
Stroker Displacement: 4.9
Location: Michigan

Looking for Input

Post by jsawduste »

Sure has been quite here lately. Anybody up to anything good ?

After a number of upgrades and improvements to my YJ as a whole I have come to the conclusion that changing to JTEC and using a programmed ECM that matches my setup is the next step. The tweaked SBEC makes it run decent but I know not optimum. Plenty of room for improvement in a number of different areas.

FWIW, for those running SBEC the 96 JTEC XJ harness keeps all the same sensor connectors as the SBEC.

In fact, the architecture of the SBEC to JTEC engine control is so close you could actually add the JTEC protocol using the SBEC harness by repining the SBEC or for the lazy cut and splice the wires..
nicpaige
Consistent
Consistent
Posts: 218
Joined: October 16th, 2014, 3:35 pm
Stroker Displacement: 4.6
Vehicle Year: 2000
Vehicle Make: XJ
Vehicle Model: Sport

Re: Looking for Input

Post by nicpaige »

It has been awfully quiet around here. I was offline for about a week and came back hoping to find a couple pages of new posts...bummer. I'm still waiting on some slugs for my heap.
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests