underhood switched 12v source

Dedicated forum for all things electrical... Sometimes Electrical issues can really get you stumped! Not Stroker related.
Post Reply
rammit11
Donator
Donator
Posts: 117
Joined: April 27th, 2010, 4:29 pm
Stroker Displacement: 4.6
Vehicle Year: 1998
Vehicle Make: jeep
Vehicle Model: cherokee
Location: southeastern pennsylvania

underhood switched 12v source

Post by rammit11 »

I have 1998 xj and was looking to install a map sensor adjuster. I need to find a 12v location to hook into that is switched for the adjusted voltage source under the hood . Anybody have any ideas on where to tap into?
rainman
I think I'll order a "tab"
I think I'll order a "tab"
Posts: 44
Joined: March 30th, 2011, 5:00 am
Stroker Displacement: 4.6
Vehicle Year: 1995
Vehicle Make: Jeep
Vehicle Model: XJ

Re: underhood switched 12v source

Post by rainman »

How about the asd relay in the power distrubition center?
Might be a bit noisy cause of the coil but.
Obd1 scanner.
'95 sport,4.6 stroker, 4.5" lift, 32"s, 4:10's, 8.25&SYE, taurus fan
Sydney Australia
rammit11
Donator
Donator
Posts: 117
Joined: April 27th, 2010, 4:29 pm
Stroker Displacement: 4.6
Vehicle Year: 1998
Vehicle Make: jeep
Vehicle Model: cherokee
Location: southeastern pennsylvania

Re: underhood switched 12v source

Post by rammit11 »

Thanks for the suggestion, but I have been busy and didn't get back to update . I have located an ignition on only 12v feed, the wire that feeds the low brake sensor. The wire runs in the perfect spot in close to the proximity of the map sensor so I don' t need to run a mile of wire. I think that it is ok to tap into that circuit , anybody has any more feedback I would appreciate it.
User avatar
SilverXJ
Global Moderator
Global Moderator
Posts: 5790
Joined: February 14th, 2008, 7:14 am
Stroker Displacement: 4.6L
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee
Location: Radford, Va

Re: underhood switched 12v source

Post by SilverXJ »

rainman wrote:How about the asd relay in the power distrubition center?
Might be a bit noisy cause of the coil but.
That would be my suggestion as well.
rammit11 wrote:Thanks for the suggestion, but I have been busy and didn't get back to update . I have located an ignition on only 12v feed, the wire that feeds the low brake sensor.
That sounds like a good idea. I don't think its hot with the engine off so it should be ideal. BTW its not a low brake fluid sensor, but a pressure differential sensor between the front and rear brake systems. When there is a great loss of pressure in either systems the shuttle valve moves and trips the sensor switch.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest