Jeep Strokers

can anybody post the timing maps their using? i know shit about timing and would love to get better then 10 mpg till i can afford to take it to a tuner and have it tuned right

What kind of timing are you running now?

here's my current timing map

Telling us your setup would help. Timing demands are heavily dependent on the configuration.

lunati 63501 installed straight up. bored .020, 99+ intake, 68mm throttlebody, 4.2 crank, aw4, np242, 35's with 4.10 gears

So, I take it this is normally aspirated ? I see what looks like map going up to 400 (kPa ?) It's hard for me to read the numbers, but I would say, you want to adjust your timing so that you are running the minimum amount for maximum torque. If you are limited to street tuning, I would recommend driving around, datalog, and watch where you hover in the map, try bumping timing a few degrees at a time. The timing can be considerable more advanced at part throttle than at full throttle. How is you lambda ?

yes naturally aspirated. afr's are all pretty good, well within spec. i really wanted to get a knock sensor before starting with timing adjustments but i can't afford to keep driving it at 10 mpg. so i'm assuming i increase the timing at cruising loads but leave the wot loads alone? how do i know when i've gone too far? or not far enough?

The timing does not look too unreasonable, have you verified that indicated timing matches measured?

no i haven't. guess i need to break out the timing light and check it