hi. im doing a 4.0 head and fuel injection on my 76 cj.
I have the wiering harness out of a 93 wrangler. got all my sensors and everything hooked up today.
however when i crank it i have no spark. i measured with ignition turned on i have 12v at the coil.
all i have hooked up otherwise is the three grounds from the ecu pin# 5,11 and 12. got pin# 3 at b+ and pin# 9 at ignition power.
all i can think of that could cause me to not have any spark is the park/neutral switch.
on my schematic it says that the park neutral switch is pin# 30 at the ecu but not where it goes.
does know how to "trick" the park neutral switch. Or have any other ideas to what might be the problem?
I really appreciate any help i could get before i tear my hear out thinking about this.
4.0 mpi head swap. no spark:(
-
- Posts: 1
- Joined: June 28th, 2012, 7:55 pm
- Vehicle Year: 1976
- Vehicle Make: jeep
- Vehicle Model: cj
- amcinstaller
- I love JeepStrokers.com!!
- Posts: 607
- Joined: May 22nd, 2008, 11:57 pm
- Stroker Displacement: 4.6L
- Vehicle Year: 1980
- Vehicle Make: AMC
- Vehicle Model: Spirit
- Location: Red Deer, AB, Can
Re: 4.0 mpi head swap. no spark:(
the neutral safety wire goes to the neutral/park output on your tranny if its an auto. otherwise you can just ground it or wire a fancy clutch wire for starting.
1980 AMC Spirit Restomod in Progress
SilverXJ wrote:Roller rockers won't help that mess you have created. Nor will God for that matter.
-
- Posts: 1
- Joined: July 9th, 2013, 7:20 pm
- Stroker Displacement: 4.0
- Vehicle Year: 1972
- Vehicle Make: IH
- Vehicle Model: ScoutII
Re: 4.0 mpi head swap. no spark:(
Are you just using the ecu with no pcm (relay board)?
Who is online
Users browsing this forum: No registered users and 16 guests