Jeep Strokers

What do you all think about the borla header? If you would change something about it what would it be?

Im thinking about extending the secondary pipes a bit still going to be 2" secondaries and putting a 3" collector on it. Thoughts concerns? ??

What's wrong with the waay it is?

Trying to make it better then it is and this site has a large number of very intelligent jeepers on it.

I've had the Borla for years but do wish it had at least a 2.5" out instead of 2.25". I think Dino modified his to 2.75". 3" might be too big and lose some down-low torque, but I don't know. 2.25" is too small for my stroker is what I know.

The borla header comes with a 2 1/4 inch collector and the conecting pipe to the cat is the same size. Consider that the factory pipe gets "crushed" down to 1 7/8" because of the front driveshaft and the borla lookes like a star! But could it be better? If it were a 2 piece setup like the pacesetter with longer secondaries? Only in stainless.

With no encouragement from anyone the surgery is under way and more pics to follow. Just not tonight ive got a pt test for wlc. Maybe tomorrow.

Getting there.

Some more work once its on my jeep but this is basicaly it! What do y'all think?

Ta da!

Great work. Only wish you would have done a before and after dyno run to verify the real difference.

Should it work better? -'looks' like it should, In theory...
Will it work better? -only the dyno knows for sure.