Need your input (Selling my toy)

Off topic, play nice. No Nudity, Pornographic material etc..
Post Reply
User avatar
Jeep4xb4u
Donator
Donator
Posts: 75
Joined: August 3rd, 2008, 6:44 pm
Stroker Displacement: 4.6L
Vehicle Year: 1988
Vehicle Make: XJ 2dr
Vehicle Model: Sport
Location: BAY AREA / CA
Contact:

Need your input (Selling my toy)

Post by Jeep4xb4u »

Hey guys,

Been awhile and I don’t mean to drop in a blast the forum, but I’m going to part with my toy and I was hoping I could reach out to you guys for a little input on price.

1988 2dr Cherokee sport. My first car when I turned 15. It’s been babied and will be missed. For the year, it’s extremely clean and has never been mudded or off-road since I have owned/built it. It’s got its few dings and dents, also has some pealing clear coat on the roof that I intend to Rhino Line. Fun little jeep to drive, awesome amount of torque, could smoke the tires if you wanted it to. Fun to hop on small V8 cars or rice rockets at the red light. Runs extremely strong and has less than 5k on the new engine and transfer case. Sad to see it go but have higher priorities right now. Lots of attention to detail put into the engine. Comes with a complete spare dash with OE radio, the project D44 axle which is complete but would need to be reassembled or built up to your specs. I also have a crap ton of parts that I have acquired over the past decade of owning/building this thing.

Engine build:
http://www.jeepstrokers.com/forum/viewt ... f=8&t=1180

Couple Exterior Shots:
http://i509.photobucket.com/albums/s331 ... C00815.jpg
http://i509.photobucket.com/albums/s331 ... C00827.jpg
http://i509.photobucket.com/albums/s331 ... C00834.jpg
http://i509.photobucket.com/albums/s331 ... age004.jpg

Engine:
4.6L
-4.0L Block 0.00: deck / 89 head and intake (CA smog)
-4.2L Crankshaft
-4.0L polished rods
-Hesco H-264-14B Camshaft and lifters
-Diamond pistons 24cc
-Total Seal rings
-ARP Connecting rod, mains and head bolts
-Clevite 77 Main,Cam,and Rod bearings
-JP Double roller Timing Set (0 Degrees)
-Stock Sealed Power stock rocker arms / hardware
-BB Chevy performance springs, caps and keepers
-Meling HV oil pump
-Bored throttle body 60mm
-Hesco HV water pump/thermostat housing
-AC Delete/alternator relocation
-Home brewed Port/polish on head and the first 5" of intake runners
-Accel cap/rotor
-Taylor 8.3mm wires
-Powermaster 150amp Alt

Drive train:

AW4
NP231 (Fully rebuilt less than 5k ago)
Tom Woods shaft w/Hd SYE
Dana 30/35c Yukon
Open 4.88s in the rear / 3.55s front (no front shaft installed)
Rear manche Dana 44 (Project axle comes with)


Suspension:

Mickey Thompson 15x8 Classics
Interco 33x12.5 Thornbirds (suck)
Rusty's 6.5" Coils
Rusty's 6.5" Leafs
Rusty's long arm
Rusty's Trac bar and modified drop bracket
JKS Discos
Poly motor and trans mounts
Drop pit arm
Rusty's nitro shocks
Steering conversion

Other:

3 core radiator conversion
Dual Permacool Electric fans
Dual Spal adjustable thermostats / relays
Cold air intake
Flowmaster 40 series dual out
Hesco ignition enhancement kit
Optima red top
Auto start alarm
Aftermarket electric door locks
Led interior lights
Tuffy center consol
Limited gauge cluster
Autometer mini warning light (oil pressure)
Autometer UltraLite gauges
- Wideband A/F
- Trans Temp
- Oil Temp
Scat seats
B&M Mega Shifter with custom consol
Grant GT wheel

Stereo

Alpine CDA-9884 Head
JL 4g Power / Ground / Fuses
RF Gama low levels
2 x RF P.2 10's 4 ohm DVC, Bridged to 2ohm, sealed box's .90qf
2 x RF 3.5" 2 way Highs
2 x Polk 6.50 coax
88' XJ 2dr
4.0l / AW4 / NP231 / D35c
6.5" Long Arm Lift - 33x12.5's - 15x8 Mickey's

Currently working on 4.6l / D44 Swap
User avatar
Jeep4xb4u
Donator
Donator
Posts: 75
Joined: August 3rd, 2008, 6:44 pm
Stroker Displacement: 4.6L
Vehicle Year: 1988
Vehicle Make: XJ 2dr
Vehicle Model: Sport
Location: BAY AREA / CA
Contact:

Re: Need your input (Selling my toy)

Post by Jeep4xb4u »

*Bump*

Any input on asking prices?
88' XJ 2dr
4.0l / AW4 / NP231 / D35c
6.5" Long Arm Lift - 33x12.5's - 15x8 Mickey's

Currently working on 4.6l / D44 Swap
User avatar
superj
Donator
Donator
Posts: 70
Joined: May 18th, 2012, 5:12 pm
Stroker Displacement: 4.5
Vehicle Year: 1987
Vehicle Make: jeep
Vehicle Model: wrangler
Location: corpus christi, texas

Re: Need your input (Selling my toy)

Post by superj »

how much are other cherokees of that year going for? a lot of the mods you have done or added won;t increase the price, unfortunately. but with it being really clean, you can run it way on the high end of the price list and maybe a little bit more and hopefully a jeep person will come along and realize what you have done and get it. otherwise, it might be for sale for a fair amount of time if you list it too high.
We broke something, I think it was traction.
User avatar
SilverXJ
Global Moderator
Global Moderator
Posts: 5790
Joined: February 14th, 2008, 7:14 am
Stroker Displacement: 4.6L
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee
Location: Radford, Va

Re: Need your input (Selling my toy)

Post by SilverXJ »

superj wrote:how much are other cherokees of that year going for? a lot of the mods you have done or added won;t increase the price, unfortunately. but with it being really clean, you can run it way on the high end of the price list and maybe a little bit more and hopefully a jeep person will come along and realize what you have done and get it. otherwise, it might be for sale for a fair amount of time if you list it too high.
x2. I'd say ask $5k and let them talk you down a bit.
TXslayer
Noob
Noob
Posts: 15
Joined: June 19th, 2012, 12:14 am
Vehicle Year: 1990
Vehicle Make: Jeep
Vehicle Model: Cherokee

Re: Need your input (Selling my toy)

Post by TXslayer »

(if I had the money) I'd have no problem paying 4k for a cherokee that clean and well built.
Post Reply

Who is online

Users browsing this forum: No registered users and 27 guests