Jeep Strokers

I used a 1994 XJ block with a 1989 YJ crank and rods. I have the wiring harness for the XJ block.

I am wondering if I can use the 1989 YJ flywheel when I finish the assembling of the engine. I know the new wiring harness will need a CPS. The CPS reads the notches on the flywheel.

Should I just pony up the money for a 1994 XJ flywheel to be sure the notches for the CPS are correct?

What have those that have built a stroker done?

You will need the flywheel that matches the PCM you will be using. So you will need a 94 (or what ever years interchange ) for 94 engine electronics.

That is what I figured. I have ordered the new flywheel already.