Page 1 of 1
Renix Flexplate to 998 Convertor ?
Posted: October 1st, 2009, 11:02 am
by milnersXcoupe
Will the 998 convertor bolts line up with a Renix Flexplate
or does this require drilling new mounting points?
Re: Renix Flexplate to 998 Convertor ?
Posted: October 1st, 2009, 6:16 pm
by TurboTom
Depending on the year, you may have to redrill 1 hole as the later model engines used a semmetrical pattern and the early converters have 1 hole offset.
PTC made my converter with both patterns. I only have delt with a 2000 4.0
Re: Renix Flexplate to 998 Convertor ?
Posted: October 2nd, 2009, 3:53 am
by SilverXJ
I know on the ZJ it was 95 or 96 that they went from one offset hole to symmetrical. Maybe the same on yours.