Renix Flexplate to 998 Convertor ?

AMX's, Gremlins, Pacers, Ramblers, Eagles etc.
Post Reply
User avatar
milnersXcoupe
Posts: 3
Joined: November 29th, 2008, 4:51 pm
Vehicle Year: 1981
Vehicle Make: AMC
Vehicle Model: EAGLE 50
Location: new york

Renix Flexplate to 998 Convertor ?

Post by milnersXcoupe »

Will the 998 convertor bolts line up with a Renix Flexplate
or does this require drilling new mounting points?

:stick:
User avatar
TurboTom
I made it to triple digits!
I made it to triple digits!
Posts: 191
Joined: August 25th, 2008, 11:11 pm
Location: Winchester Virginia
Contact:

Re: Renix Flexplate to 998 Convertor ?

Post by TurboTom »

Depending on the year, you may have to redrill 1 hole as the later model engines used a semmetrical pattern and the early converters have 1 hole offset.
PTC made my converter with both patterns. I only have delt with a 2000 4.0
Remember, Sometimes I post after drinking!
1979 AMC Spirit
Building a Turbo 2.5
I am not very smart!
User avatar
SilverXJ
Global Moderator
Global Moderator
Posts: 5789
Joined: February 14th, 2008, 7:14 am
Stroker Displacement: 4.6L
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee
Location: Radford, Va

Re: Renix Flexplate to 998 Convertor ?

Post by SilverXJ »

I know on the ZJ it was 95 or 96 that they went from one offset hole to symmetrical. Maybe the same on yours.
Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests