Acceptable Crank Tolerances
Posted: August 11th, 2009, 7:33 am
howdy gang
I'm having a hard time finding a decent remanufactured crank. Both that I've ordered have had .005 runout and ~.001 taper on the rod journals. The filets on the rod journals look aweful too. Kinda like they didn't even dress the sides.
Are we being too picky? Is there a grinder that you have found that can grind a flat, round and straight crank?
I'm having a hard time finding a decent remanufactured crank. Both that I've ordered have had .005 runout and ~.001 taper on the rod journals. The filets on the rod journals look aweful too. Kinda like they didn't even dress the sides.
Are we being too picky? Is there a grinder that you have found that can grind a flat, round and straight crank?