howdy gang
I'm having a hard time finding a decent remanufactured crank. Both that I've ordered have had .005 runout and ~.001 taper on the rod journals. The filets on the rod journals look aweful too. Kinda like they didn't even dress the sides.
Are we being too picky? Is there a grinder that you have found that can grind a flat, round and straight crank?
Acceptable Crank Tolerances
-
- Donator
- Posts: 247
- Joined: July 31st, 2008, 12:28 pm
Re: Acceptable Crank Tolerances
Nobody?
Who is online
Users browsing this forum: No registered users and 29 guests