intake
Posted: May 7th, 2009, 6:51 pm
wasnt sure where to post this question but i was wondering if i could buy a 99+ intake and use my 91 throttle body, fuel rail, and sensors?
http://car-part.com/
or
EBAY
Jeep Strokers
Jeep - AMC 4.0L and 4.2L Stroker Enthusiasts
https://www.jeepstrokers.com/forum/
intake
Page 1 of 1
Re: intake
Posted: May 8th, 2009, 6:52 am
Re: intake
Posted: May 8th, 2009, 11:17 am
sorry for the misunderstanding. i already have a line on a bare intake 99+ was just wondering if the goodies from my 91 would fit on it and work.
Re: intake
Posted: May 8th, 2009, 11:59 am
I fail reading comprehension... 
Vacuum ports are in slightly different locations. rerouting will be needed.
You will either need a 96+ PS pump and bracket, or modify the 1991 bracket to work.
If you switch to the 96+ PS pump and bracket, your idler pulley needs to come off and you will need a belt for a 99+ model.
Injectors, rails, sensors, etc. will all work.
Vacuum ports are in slightly different locations. rerouting will be needed.
You will either need a 96+ PS pump and bracket, or modify the 1991 bracket to work.
If you switch to the 96+ PS pump and bracket, your idler pulley needs to come off and you will need a belt for a 99+ model.
Injectors, rails, sensors, etc. will all work.
Re: intake
Posted: May 8th, 2009, 1:39 pm
great thats what i was wanting to hear. its going in a cj without power steering so thats not a problem. although i need to do some research as to how i can put ps on my jeep but thats down the road.