Jeep Strokers

Getting close

how much were the pistons?

$475 they may not be this price now.
Just checked the catalog. $429 now.
http://www.bulltear.com/catalog/product ... 4bk2st6gj4
J.B.

Almost there!

Looks good! I like the orange a lot, that's what I was planing on painting mine! keep up the good work!

I like how it matches the RRs and clutch

Yup that's a brand new AX-15 behind the longest stroker build in history.

na yours isn't the longest in history. i started mine 2 years ago and still haven't finished it...almost have all the parts though and i have an assembled short block. 1 day i'll have the cash to finish the head


am i seeing things or is that the renix intake and throttle body?

Yuppers it's Renix. Decided to stay with that to minimise the difficulty of the swap.

You should atleast get the throttle body bored out or your going to suffocate that new engine

It'l never go over 4K.
I did the calculations from "Performance Fuel Injection Systems".
If I get a little time I'll post the calcs. But if I remember correctly, according to the calcs the TB should be fine.
I realize that the real word is sometimes quite different than calculations, but as I said before, I kind of want to change a little at a time.
This makes t-shooting easier. I'll be happy just to get it in and running!
I have half a dozen TB's from different Jeeps floating around the shop, so I can experiment after initial startup.
J.B.

P.S.
I pulled the engine April 2010!

I'm sticking with my renix tb as well but I'm going to have it bored out to 60mm so I don't have to buy all the expensive adapters to make the newer tbs work with the older computer but I'm going with the newer intake for the better flow and I figure the intakes only dealing with air and vacuum so it can't really mess anything up

Newer intake + RENIX TB still ='s Adapters...

ya but that i can make out of a $10 piece of aluminium....which is what i did