Page 2 of 2
Re: AMC/Jeep gear drive, that right there is rare as hen's teeth
Posted: March 2nd, 2011, 6:55 pm
by SIXPAK
Mr.Mopar wrote:Does Xceldyne actually make the Belt Drive? I can't find anything on their site.
What the part # and cost?
Thanks
Yes and No. They do make the belt drive in the pic BUT it's for a BBC. I adapted it to fit my needs. BBC had the closest measurement for the Center to center and readily available belt drive to adapt over. Of course that means an idler is needed.
Danny Bee makes one for the FORD FE that has the same center to center but I did not like it much. Jesel had one in the works for the FORD FE also but at the time it was not done yet.
Re: AMC/Jeep gear drive, that right there is rare as hen's teeth
Posted: March 3rd, 2011, 10:59 am
by amcinstaller
so what about the cover thats behind the belt drive? that was obviously custom made as well, CNC machined or ? this has been brought up a few times here, and i am wondering now how often its actually been done.
Re: AMC/Jeep gear drive, that right there is rare as hen's teeth
Posted: March 3rd, 2011, 4:44 pm
by SIXPAK
Yes a portion of the work was done CNC and it was finished off on a standard digital readout Bridgeport.
Re: AMC/Jeep gear drive, that right there is rare as hen's teeth
Posted: March 3rd, 2011, 5:23 pm
by Mr.Mopar
How streetable is the belt drive?
Thanks
SIXPAK wrote:Yes a portion of the work was done CNC and it was finished off on a standard digital readout Bridgeport.
Re: AMC/Jeep gear drive, that right there is rare as hen's teeth
Posted: March 4th, 2011, 3:45 pm
by pitch black
mine is mostly jesel for the belt drive for the jeep