reusing a head gasket?

Newbies, and basic Stroker Recipes... Get started with your first stroker here!!
Post Reply
User avatar
SilverXJ
Global Moderator
Global Moderator
Posts: 5790
Joined: February 14th, 2008, 7:14 am
Stroker Displacement: 4.6L
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee
Location: Radford, Va

Re: reusing a head gasket?

Post by SilverXJ »

Did you take any measurements with a dial indicator or anything?
Top
billy_bob
Learning to use the board
Learning to use the board
Posts: 34
Joined: July 10th, 2009, 8:29 am
Stroker Displacement: 4.7
Vehicle Year: 1994
Vehicle Make: jeep
Vehicle Model: cherokee

Re: reusing a head gasket?

Post by billy_bob »

nope i dont have one. im guessing since you asked that i would need one to see how flat it actully is?
90 block, 94 7120 head and rods, IC944 .060 21cc, comp 68-239-4 and of course the 258 crank. my first full build and i did pretty damn good
Top
billy_bob
Learning to use the board
Learning to use the board
Posts: 34
Joined: July 10th, 2009, 8:29 am
Stroker Displacement: 4.7
Vehicle Year: 1994
Vehicle Make: jeep
Vehicle Model: cherokee

Re: reusing a head gasket?

Post by billy_bob »

i just looked at the valves, i had seen some videos and you could see the valves not going down as far, but i guess theres different levels of going flat
90 block, 94 7120 head and rods, IC944 .060 21cc, comp 68-239-4 and of course the 258 crank. my first full build and i did pretty damn good
Top
User avatar
SilverXJ
Global Moderator
Global Moderator
Posts: 5790
Joined: February 14th, 2008, 7:14 am
Stroker Displacement: 4.6L
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee
Location: Radford, Va

Re: reusing a head gasket?

Post by SilverXJ »

You need to measure. Eyeballing it doesn't work as even a little bit can screw things up.
Top
Post Reply

Return to “Stroker Basics”

Who is online

Users browsing this forum: Amazon [Bot] and 8 guests