Welcome to www.JeepStrokers.com!!
Not yet a registered user? You are required to Register before you can post within this topic.

199

AMX's, Gremlins, Pacers, Ramblers, Eagles etc.
Post Reply
User avatar
crazygogo
Making Progress
Making Progress
Posts: 72
Joined: December 21st, 2014, 7:38 am
Stroker Displacement: 242 + .30 over
Vehicle Year: 2002
Vehicle Make: jeep
Vehicle Model: wj
Location: michigan motorcity

199

Post by crazygogo » December 30th, 2014, 8:15 pm

anyone used with a 199 crankshaft in a 4.0?

SIXPAK
Consistent
Consistent
Posts: 226
Joined: March 8th, 2008, 5:34 am
Stroker Displacement: 280

Re: 199

Post by SIXPAK » December 31st, 2014, 12:38 pm

I have not used one but I do have one 199 crank in the garage. If I were to use it I would have to machine the crank to accept the pilot for my 904 converter as it only has a small pilot. After that it is just the matter of having a set of pistons made. Not sure I would use 4.0 rods though. I have not got that far yet.

User avatar
crazygogo
Making Progress
Making Progress
Posts: 72
Joined: December 21st, 2014, 7:38 am
Stroker Displacement: 242 + .30 over
Vehicle Year: 2002
Vehicle Make: jeep
Vehicle Model: wj
Location: michigan motorcity

Re: 199

Post by crazygogo » January 3rd, 2015, 7:53 pm

how much machine work is need to have it accept the re42 or aw4 tranny?

User avatar
crazygogo
Making Progress
Making Progress
Posts: 72
Joined: December 21st, 2014, 7:38 am
Stroker Displacement: 242 + .30 over
Vehicle Year: 2002
Vehicle Make: jeep
Vehicle Model: wj
Location: michigan motorcity

Re: 199

Post by crazygogo » March 30th, 2015, 11:15 am

if you use 6 of the 4g54t turbo rods and machine a tiny bit of the rods width they will bolt in and then run sum g.m 3.898 pistons and then bore of a 4.0 and there u go.. very long rod 3.5L roughly

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest