Welcome to www.JeepStrokers.com!!
Not yet a registered user? You are required to Register before you can post within this topic.

Rod bearing tang grooves

Performance mods and Advanced Stroker discussion.
Post Reply
User avatar
MunkMaster
Donator
Donator
Posts: 31
Joined: March 24th, 2017, 8:18 am
Vehicle Year: 1996
Vehicle Model: Cherokee

Rod bearing tang grooves

Post by MunkMaster » July 13th, 2018, 9:25 pm

I have a set of Scat rods that have 2 bearing tangs in it. I am pretty sure they are supposed to line up with the same side as the main bearing tangs but not 100% sure. Am I correct on this? And if so can someone tell me which side the main bearing tangs are on (1996 4.0 block) my block is at the machine shop and I'm itching to put the piston and rods together just to feel like something is getting done.


Thanks

P.S. I tried attaching a couple different photos of the rods and such but kept getting this error

"ERROR
It was not possible to determine the dimensions of the image. Please verify that the URL you entered is correct."

Russ Pottenger
I love JeepStrokers.com!!
I love JeepStrokers.com!!
Posts: 639
Joined: August 15th, 2009, 1:27 am
Stroker Displacement: 4.7
Vehicle Year: 2000
Vehicle Make: Jeep
Vehicle Model: Cherokee

Re: Rod bearing tang grooves

Post by Russ Pottenger » July 14th, 2018, 9:46 am

Bearing tangs are on the driver side.

User avatar
MunkMaster
Donator
Donator
Posts: 31
Joined: March 24th, 2017, 8:18 am
Vehicle Year: 1996
Vehicle Model: Cherokee

Re: Rod bearing tang grooves

Post by MunkMaster » July 14th, 2018, 3:32 pm

Russ Pottenger wrote:
July 14th, 2018, 9:46 am
Bearing tangs are on the driver side.
Thanks Russ

I shot you an email but the question wasn't an emergency so I didnt see the point of calling since the block went back to the machine shop.
Cheers :cheers:

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests