Welcome to www.JeepStrokers.com!!
Not yet a registered user? You are required to Register before you can post within this topic.

fuel rail / tranny line o-ring kits

Newbies, and basic Stroker Recipes... Get started with your first stroker here!!
User avatar
gonridnu
Movin on up ^
Movin on up ^
Posts: 303
Joined: December 22nd, 2008, 9:36 am
Stroker Displacement: 4.6L
Vehicle Year: 1989
Vehicle Make: Jeep
Vehicle Model: XJ 2 door

fuel rail / tranny line o-ring kits

Postby gonridnu » April 15th, 2010, 7:36 am

Does anyone know where to get the o-ring "modules" that fit the fuel lines and tranny lines other than at the dealership where they are like $10 a pop? I'd like to replace them all while in there and that equates to about 9 units or so. Does Napa have them? If so can someone supply a part number?

yuppiexj
Donator
Donator
Posts: 319
Joined: February 13th, 2008, 7:31 pm
Stroker Displacement: 4.5 needs assembly
Location: Fredercksburg VA (land of nothing)

Re: fuel rail / tranny line o-ring kits

Postby yuppiexj » April 15th, 2010, 8:43 am

if you have bulk o-rings simply get the clips themselves from your local parts store.

Dorman (AKA HELP! brand) 800-005 and 800-006 (5/16" and 3/8" respectively)

Should be around $4 each.


if you want to dig for the full reload kit part number, here's a starting point:
http://www.dormanproducts.com/c-386-fuel-line-connectors-retainers.aspx
TurboTom wrote:i will eat my words later if need be.

TurboTom wrote:Not sure of your rules...but you need to start with an engine that works best for the rules and cheat from there!

Proud owner of many stroker parts, that have not yet spontaneously assembled themselves.

Bodo
Donator
Donator
Posts: 247
Joined: July 31st, 2008, 12:28 pm

Re: fuel rail / tranny line o-ring kits

Postby Bodo » April 15th, 2010, 9:00 am

Try BK 730-4978. It's a transmission line connector.


Return to “Stroker Basics”

Who is online

Users browsing this forum: No registered users and 1 guest