Welcome to www.JeepStrokers.com!!
Not yet a registered user? You are required to Register before you can post within this topic.

Valve train noise when cold

For all non stroker / performance related problems and discussion.
Post Reply
User avatar
SkylinesSuck
Donator
Donator
Posts: 342
Joined: February 14th, 2009, 11:11 pm
Stroker Displacement: 4.6L
Vehicle Year: 1998
Vehicle Make: Jeep
Vehicle Model: Wrangler
Location: Northern VA

Valve train noise when cold

Post by SkylinesSuck » December 29th, 2017, 5:11 am

It's been pretty chilly here as I'm sure a lot of you are also experiencing. Single digit lows and highs around freezing or lower. I have noticed a lot more valve train noise on initial start up and for the first couple of minutes until it starts getting warmed up. It's more than I remember over the past couple winters. I do remember a bit of piston slap before that went away rather quick, but this isn't that.

I just installed a new cam and lifters over the spring (thanks again Russ) and went two sizes smaller on the push rods (.1 smaller?). I'm wondering if maybe that was too short? Could not enough lifter preload cause this and if so, is it anything to worry about? I try to let it idle a few minutes to warm up, but I'm not always able.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest