Hello all, new to the stroker community here...
I have a '74 258 motor (with T14 and D20) that runs. I'm going to get a running '97 4.0 complete with ECM this weekend from a wrecked vehicle. My son and I are getting ready to start a stroker project for our '95 YJ. The YJ runs and has a 2.5 in it.
I'm assuming these 2 motors will make for a good stroker? I haven't read anything to the contrary...
I've been searching the site here, what a great resource!
Besides the ECM and engine harness is there anything else I should get from the donor vehicle? I was going to grab the air filter/intake plumbing as well.
If there are any threads that you can point me in the direction of that would be of help, I would apprecite it.
Thanks!
-z
I have a running 4.2 and 4.0
-
- Posts: 1
- Joined: January 10th, 2019, 10:08 am
- Vehicle Year: 1995
- Vehicle Make: Jeep
- Vehicle Model: YJ
- Cheromaniac
- I live here
- Posts: 3187
- Joined: March 8th, 2008, 12:58 pm
- Stroker Displacement: 4563cc
- Vehicle Year: 1992
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: Cyprus
- Contact:
Re: I have a running 4.2 and 4.0
You could use the 4.2 crankshaft together with the 4.0 rods and Russ Pottenger supplied custom pistons.
In addition to the ECU and engine harness, you'll need the fuel lines and the fuel pump/regulator assembly from the '97 as this has a returnless fuel system.
In addition to the ECU and engine harness, you'll need the fuel lines and the fuel pump/regulator assembly from the '97 as this has a returnless fuel system.
1992 XJ 4.6 I6 - 5MT - Stroker build-up, Stroker "recipes" Sold
1995 Mustang GT - 4AT - Modded Sold
2006 Mustang GT - 5MT - Modded Midlife Crisis Car
1995 Mustang GT - 4AT - Modded Sold
2006 Mustang GT - 5MT - Modded Midlife Crisis Car
Who is online
Users browsing this forum: No registered users and 19 guests