94 manual tranny bolted to a 89 crank
-
- Noob
- Posts: 14
- Joined: April 12th, 2008, 12:11 pm
- Stroker Displacement: 4.7
- Vehicle Year: 1994
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
94 manual tranny bolted to a 89 crank
got the stroker motor together and in and went to bolt up the transmission i see where the pilot bushing goes on its different in the 89 crank i tried removing that spacer on the 94 crank but it didn't work i pickup a new pilot bushing to put on the 89 crank pilot bushing from a 94 an i missing something or going at this all wrong to bolt the tranny up this is the last thing i go to do to fire this up and see how it workin
- Shark
- Consistent
- Posts: 268
- Joined: February 14th, 2008, 8:51 pm
- Location: Tampa Bay
Re: 94 manual tranny bolted to a 89 crank
if you post some pictures it might give me a better idea of the situation here. is it the original tranny? what did you get the crank out of?
'91 MJ 4.0 ax15 Resto-mod street truck project, stroker candidate
'93 XJ 2door 4.0 aw4 np231 7" lift 33's
'95 XJ 4door 4.0 aw4 2" 31's
'95 XJ 4door 4.0 aw4 np231 4" lift 31's RIP
'93 XJ 2door 4.0 aw4 np231 7" lift 33's
'95 XJ 4door 4.0 aw4 2" 31's
'95 XJ 4door 4.0 aw4 np231 4" lift 31's RIP
- gradon
- Donator
- Posts: 1353
- Joined: February 13th, 2008, 5:33 pm
- Stroker Displacement: 4.6/280ci
- Vehicle Year: 1996
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: DC
Re: 94 manual tranny bolted to a 89 crank
The earlier trannies had a .59" internal diameter and the later ones had a .75" internal diameter. I don't know what the external diameter of the earlier ones are, but the later ones were 1" IIRC.
- gradon
- Donator
- Posts: 1353
- Joined: February 13th, 2008, 5:33 pm
- Stroker Displacement: 4.6/280ci
- Vehicle Year: 1996
- Vehicle Make: Jeep
- Vehicle Model: Cherokee
- Location: DC
Re: 94 manual tranny bolted to a 89 crank
I just had this issue with my stroker build and an early 80's crank. The earlier trannies had a .59" internal diameter and the later ones had a .75" internal diameter. I don't know what the external diameter of the 89 crank is, but on my 81-86 crank, it was ~1.06. I ended up using a bushing(not bearing) from Advanced and it was the pb77($3), with a slightly larger than 1" OD and the .75" ID.
-
- Noob
- Posts: 14
- Joined: April 12th, 2008, 12:11 pm
- Stroker Displacement: 4.7
- Vehicle Year: 1994
- Vehicle Make: Jeep
- Vehicle Model: Wrangler
Re: 94 manual tranny bolted to a 89 crank
Thanks thats the info i needed
Who is online
Users browsing this forum: Ahrefs [Bot] and 12 guests