Jeep Strokers

just out of curiosity how much did you pay to have the pistons dished?

Sorry fedrusion, I missed your question about the depth. It's .200" from the top face of the piston.

Riversidefort, I did them myself, I program and run a CNC milling machine for a living. PERKS!
I've done stock pistons for myself and silvolites for one of the guys on the yahoo group. Still have the fixturing, PM me if you need someone to machine some.

i must say, that is quite the perk

oletshot wrote:Sorry fedrusion, I missed your question about the depth. It's .200" from the top face of the piston.

Riversidefort, I did them myself, I program and run a CNC milling machine for a living. PERKS!
I've done stock pistons for myself and silvolites for one of the guys on the yahoo group. Still have the fixturing, PM me if you need someone to machine some.

how much would you charge to machine a set of pistons?

how much would you charge to machine a set of pistons?

Are you supplying them?

oletshot wrote:

how much would you charge to machine a set of pistons?

Are you supplying them?

sure

tigerShark wrote:

oletshot wrote:

how much would you charge to machine a set of pistons?

Are you supplying them?

sure

PMed you.

I've got my extra set from the 4.2 that I'm going to play around with at work before I try to dish the pistons from the 4.0 that I'm planning to use. Thanks for the depth.

out of curiosity, have you completed the motor those pistons you machined are going into? if so, how are they doing?

Haven't finished the build, yet. Even after finishing the engine, before it can be installed, I need to aquire all the parts necessary to swap a 4.5/AW4 combo into a 2.5/30RH YJ.